|
|
 |
| ON/OFF thermostat for controlling up to 300 watts of any heat source. Size: 75x52x27mm (excluding cables.
The ministat will orperate any mains voltage heater as listed below
MINISTAT300 Bulbs, heatmats etc upto 300w
Do not attempt to operate the ministat with a greater load than specified . To do so may result in damage to the ministat
Connections
Connect the main cable from your heater to the heater output of the ministat (fitted main sockets) using a suitable 13a plug (fitted with a 3a fuse)
Connect the ministat to the mains supply using the fitted mains plug. please note the mains plug is fitted with a 3a fuse which must be replaced witha 3a fuse in the event of a faliure
The mains cables fitted to the ministat are coloured coded as follows
(brown - live_ (Blue-neutral) (green/yellow-earth)
INSTALLATION
Postiton the minisat sensor in the vivarium approxmately 225mm (9 inches) away from the heat source. This is to ensure the sensor is measuring air temperature and not direct heat. Always use a thermometer to check the temperature of the vivarium and adjust the ministat as required to give the required temperature.
Adjustment
A small flat blase screwdriver can be used to adjust the temperture control of the ministat. The ministat has a power indication led. When the led is lit power is being supplied to the heater. The led will go out when the desired temperature has been reached.
When using a mini stat the temperature probe should be placed in the centre of the heat mat.
|
|
|
|
|
|
| Mix 'N' Match |
Get great savings by Mix & Matching your orders.
More Info
| |
|
|
|
|